![]()
Miata Mailing List: December 1992, Message #68
sponsored by
From: (none) Subject: There's a Cricket Under My Hood Date: (none)
>Sounds like your clutch slave cylinder shaft needs some grease. This is a >common problem on Miatas. The Miata Magazine published an explanation and >quick fix a while back. Yes, but the quick fix is not permanent. Mine is no longer able to be quieted that way, although it does take the worst of it away and no longer sets my teeth on edge. When the noise came back after the "quick fix" had been applied to mine, I tried lubricating it again. No lubricant I could find worked at all, until I asked the dealer -- they suggested motorcycle chain lube. I tried that and it did make a difference. It stays in place much better than other lubricants. The problem apparently is not just the end of the clutch slave rod, but the clutch actuating arm itself eventually starts to squeak on its pivot. The dealer knew of no permanent fix. Martyn --------------sasmjw@unx.sas.com----(Martyn Wheeler)----DoD #293-------------- SAS Institute, Inc: (919) 677-8000 ext.7954 H: (919) 839-0092 (Raleigh, NC) "Got anything to say? No? Shut Up!" -- Stranglers IV