Miata Mailing List: August 1996, Message #98
sponsored by



     


   From: "Fletcher Blades" 
Subject: Headlight cover alignment.
   Date: Thu, 1 Aug 1996 21:41:35 -0400



I cant believe you people who are advising just pulling on the headlight   
covers....

Sure it may work, or you could just bash the hood with a hammer until it   
matches...

Here are the real instructions.

Note which corners of the headlight cover need to be raised and lowered.

Pop lights up, using button in the middle of the dash.

Use cross-head screw driver, and remove two screws holding plastic cowl   
around lights, and remove cowl. (will need a little flexing).

Now, each corner of the light cover has its own mounting screw. Loosen,   
adjust, and tighten as necessary.

Pop lights down, to check alignment, and up again to re-fit the plastic   
cowl.


Now, that wasn't too hard was it?

Fletch.