Miata Mailing List: December 1999, Message #195

sponsored by

--- Miata Racer <miataracer95@hotmail.com> wrote:
> Let me just apologize in advance if I'm initiating a
> TOC already covered 
> many times before.......

It's okay.  After all, the Miata has been with us for
a long time; how many new topics can we generate? :)

> I've been auto-xing for a year now using Mazda
> factory alignment specs.  I 
> getting an alignment today and I was going to use
> some specs. found on the 
> net, listed below.  I do use this car as a daily
> driver so I don't want to 
> be too aggressive but then again, tires are cheap. 
> Any suggestions?

I run -1.0 camber at both ends.  So far, I haven't
noticed any ill effects on tire wear, but if you're
still running a stock front bar this may be more front
camber than you need (I run a 24mm front bar with the
stock rear).  I also run less front toe-out than below
(0.02") and a tad less caster.

> FRONT
> Caster +4.7 to +5.5
> Camber -0.6 to -0.8
> Toe Out 1/16" per side
> REAR
> Caster N/A
> Camber -1.1
> Toe In 0 to 1/16" per side

Have fun!

Scot & Kate
'91 base, Silverstone Metallic
__________________________________________________
Do You Yahoo!?
Thousands of Stores.  Millions of Products.  All in one place.
Yahoo! Shopping: http://shopping.yahoo.com